1. 3D Modeling and Printing

Finishing a print

Read More
Sanding!
7 / 13

Sanding!

After the primer, I start wet sanding. 220 and 400 at this point. The goal is to get the surface as smooth as possible with no print lines visible.

After wet sanding the primer, I'll use Bondo Glazing Putty to fill any defects. When the filler dries, that too gets sanded.

  • The Print
  • Rough Sanding
  • Rough Sanded 1
  • Rough Sanded 2
  • Test fit of rear panel
  • Primer
  • Sanding!
  • More primer
  • Contrast time!
  • Wet paint
  • Dry Black
  • Untitled photo
  • Test fitting ear cap
  • No Comments
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2022 SmugMug, Inc.