1. 3D Modeling and Printing

Finishing a print

Read More
Test fitting ear cap
13 / 13

Test fitting ear cap

I printed the ear caps on the Photon too. They are too large to print whole, so I split them at a spot that would be relatively easy to reassemble them. The parts didn't mate up quite perfectly so I had to do a bit of filler along the seams. They will get a similar treatment to the helmet... sand/fill/sand/prime/repeat.

  • The Print
  • Rough Sanding
  • Rough Sanded 1
  • Rough Sanded 2
  • Test fit of rear panel
  • Primer
  • Sanding!
  • More primer
  • Contrast time!
  • Wet paint
  • Dry Black
  • Untitled photo
  • Test fitting ear cap
  • No Comments
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2023 SmugMug, Inc.